Brushless Esc V2.3 Manual [best] File

| Menu # | Beep Pattern | Parameter | Options (Move throttle up/down, then save) | | :--- | :--- | :--- | :--- | | 1 | 1 short beep | Brake Type | 1 Beep=Off (Default) / 2 Beeps=Soft / 3 Beeps=Hard | | 2 | 2 short beeps | Battery Type | 1 Beep=LiPo (Default) / 2 Beeps=NiMH | | 3 | 3 short beeps | Cutoff Voltage (Low Voltage Protection) | 1 Beep=Low (2.8V/Cell) / 2 Beeps=Med (3.0V) / 3 Beeps=High (3.2V) | | 4 | 4 short beeps | Timing Advance | 1 Beep=Low (For 2-pole motors) / 2 Beeps=Med (Most outrunners) / 3 Beeps=High (High RPM) | | 5 | 5 short beeps | Start Mode (Punch) | 1 Beep=Soft / 2 Beeps=Normal (Default) / 3 Beeps=Aggressive | | 6 | 1 long beep | PWM Frequency | 1 Beep=8kHz (Default) / 2 Beeps=16kHz | | 7 | 1 long+1 short | Motor Rotation (Locked) | Use wire swap instead |

Most V2.3 ESCs do not have a USB port or a programming card. You program them using the transmitter stick. Here is the for the V2.3 firmware. brushless esc v2.3 manual

Most models support 2-3S LiPo or 4-9 cell NiMH batteries. | Menu # | Beep Pattern | Parameter

High-performance 32-bit Cortex MCU with frequencies up to 170MHz for faster response times. Most models support 2-3S LiPo or 4-9 cell NiMH batteries