If the factory "beep" is too loud for your quiet home shack, you can adjust (Beep tone) and (Alarm tone) internally to customize the audio feedback. 4. Important Clarification: TKM-707 vs. TM-G707
: For specific jumper settings, the most comprehensive list is often found on Mods.dk (requires registration). kenwood tkm707 mods
Requires removing a specific zero-ohm resistor (jumper) on the control board. Procedure: Disconnect power and remove the top/bottom covers. Locate the control unit (behind the front panel). Find the small surface-mount jumpers labeled W1, W2, etc. Removing W1 typically opens the transmit range. If the factory "beep" is too loud for
By default, the TKM-707 is often locked to specific maritime bands (2, 4, 6, 8, 12, 14 MHz). To use it across the full 2–30 MHz range kenwood tkm707 mods
If the factory "beep" is too loud for your quiet home shack, you can adjust (Beep tone) and (Alarm tone) internally to customize the audio feedback. 4. Important Clarification: TKM-707 vs. TM-G707
: For specific jumper settings, the most comprehensive list is often found on Mods.dk (requires registration).
Requires removing a specific zero-ohm resistor (jumper) on the control board. Procedure: Disconnect power and remove the top/bottom covers. Locate the control unit (behind the front panel). Find the small surface-mount jumpers labeled W1, W2, etc. Removing W1 typically opens the transmit range.
By default, the TKM-707 is often locked to specific maritime bands (2, 4, 6, 8, 12, 14 MHz). To use it across the full 2–30 MHz range